DCS RF15I Guida di Installazione Scaricare il pdf (Pagina 12)

If the ice maker is moved, not used for an extended period of time, or will be in an area that will be near freezing tempera-

tures, it is necessary to remove any remaining water in the ice-making system.

CAUTiON

This ice maker must have all water drained and removed to prevent ice maker damage as well as possible water

damage to the surrounding area in freezing conditions. These damages are not covered under warranty.

WARNiNG

Do not use any type of anti-freeze or other solution as a substitution for properly draining the ice maker.

CLEAN ThE iCE MAkER

Cleaning the ice maker will help prevent mold and mildew growth as well as sanitize the unit for storage or when it is put

back into service.

Remove all ice from the ice storage bin.A.

Pull the reservoir drain plug to drain reservoir water.B.

Reinstall the drain plug after all of the water has drained.C.

Add ice maker cleaning solution to ice maker’s reservoir.D.

Switch the rocker switch in the grill to CLEAN position.E.

The CLEAN cycle will complete in 49 minutes.F.

DRAiNiNG AND REMOviNG WATER FROM ThE iCE-MAkiNG SySTEM

Turn off water supply to the ice maker.A.

Disconnect the water supply fitting at the inlet of the water valve.B.

Switch the rocker switch to CLEAN for approximately one (1) minute. This will energize and open the water valve and C.

remove most of the water from the water valve and the water valve’s outlet water line to the reservoir.

Switch the rocker switch to OFF position. This will energize and open the drain valve to drain the reservoir and the ice D.

maker’s drain system.

Unplug the unit from the electrical outlet.E.

Remove the back panel from the rear of the unit.F.

Disconnect the water valve’s outlet water line to the reservoir and drain the remaining water from the water line trap area.G.

Reconnect the water valve outlet water line and tighten the compression nut to a watertight seal.H.

Reinstall the unit’s back panel.I.

Clean and dry the ice maker’s storage bin.J.

Prop the door open for air circulation to prevent mold and mildew.K.

Leave the water supply line disconnected or reconnect the supply line and leave it shut off. DO NOT turn the water on L.

and allow water to enter back into the water valve.

CARE AND MAiNTENANCE

pREpARiNG ThE iCE MAkER FOR STORAGE AND WiNTERiZiNG

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 43 44

Nessun commento

DCS RF15I Guida di Installazione Pagina 12